Porter-cable BSI525 Bedienungsanleitung PDF herunterladen (Seite 11)

11- ENG

D27145

OPERATION

KNOW YOUR GENERATOR

Read this General Manual and Safety Rules before operation of your Generator.

Compare the illustration in your parts manual with your generator to familiarize yourself with

the location of various controls and adjustments. Save all manuals for future references.

GENERATOR CAPACITY

IMPORTANT: Exceeding the rated capacity of your generator can result in serious damage

to your generator and connected electrical devices. See the Wattage Calculation section in

this manual to assist you in determining the appliances and tools that can be run with the

wattage capacity of your generator.

CIRCUIT BREAKERS

Each receptacle has a circuit breaker to protect the generator from overloading. If the circuit

breaker trips, unplug all electrical loads from the generator. Let the circuit breaker cool

down. Push circuit breaker button to reset.

LOW OIL PROTECTION

To protect the generator engine from damage, the engine is equipped with a

Low Oil Protection reliability feature.

When the engine has been shut down for refueling or other purposes and the oil

level is low, the Low Oil Protection will prevent the engine from restarting until

sufficient oil has been added. NOTE: The Low Oil Protection mechanism is very

sensitive. You must fill the engine to the full mark on the dipstick to inactivate

this safety device.

IMPORTANT: Low Oil Protection will not automatically shut down the engine if

oil level becomes low while the engine is running. Always check engine oil level

before starting the engine.

BEFORE START UP

This generator has been shipped from the factory without oil in the

crankcase. Operating the unit without oil can damage the engine.

Always check engine oil level before every start. Running engine low

of oil or out of oil could result in serious damage to the engine.

Follow the steps listed below before starting generator:

1. Check engine oil. Refer to the Engine Operator's Manual for

correct grade and quantity of oil.

2. Check fuel level, fill as required. Make sure generator is turned

off and has been allowed time to cool down. Use clean, fresh,

regular unleaded gasoline with a minimum of 87 octane. Do

not mix oil with gasoline.

Never fill fuel tank completely. Fill tank to

1/2" below the bottom of the filler neck to

provide space for fuel expansion. Wipe any fuel spillage from

engine and equipment before starting engine.

Never fill fuel tank indoors. Never fill fuel tank when engine is

running or hot. Do not smoke when filling fuel tank.

Never run engine indoors or in enclosed, poor ventilated areas, en-

gine exhaust contains carbon monoxide, an odorless and deadly

gas.

3. Make sure generator is grounded in accordance with local requirements.

4. All electrical loads MUST be disconnected.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Kommentare zu diesen Handbüchern

Keine Kommentare

Porter-cable BSI525 Bedienungsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Generatoren Porter-cable BSI525