InstructionmanualThe Model and Serial No. plate is located on the mainhousing of the tool. Record these numbers in thespaces below and retain for futu
10CHANGE BIT HOLDER – MODELS 4630, 4634DISCONNECT TOOL FROM POWER SOURCE.1. Pull the Depth Stop Assembly (A)Fig. 4 from the clutch housing.2. Pull the
11DRIVING SELF-DRILLING/TAPPING SCREWS – MODELS 4640 NOTE: Maximum size screws for use with this tool are #12 wood screws and 1/4"self-drilling/t
12BRUSH INSPECTION (If applicable)For your continued safety and electrical protection, brush inspection andreplacement on this tool should ONLY be per
13SERVICEA complete line of accessories is available from your Porter-Cable•DeltaSupplier, Porter-Cable•Delta Factory Service Centers, and Porter-Cabl
14PORTER-CABLE LIMITEDONE YEAR WARRANTYPorter-Cable warrants its Professional Power Tools for a period of one year from the date of originalpurchase.
The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE •DELTA S.A.) (Lesmarques suivantes sont des
2Read and understand all warnings and operating instructionsbefore using any tool or equipment. When using tools or equipment, basicsafety precaution
3Some dust created by power sanding, sawing, grinding, drilling,and other construction activities contains chemicals known (to theState of California)
4Read all instructions. Failure to follow allinstructions listed below may result in electric shock, fire and/orserious injury. The term "power t
5d) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may resu
6ADDITIONAL SPECIFIC SAFETY RULESSAVE THESE INSTRUCTIONS!1. Hold power tools by insulated gripping surfaces when performingan operation where the cutt
72 ... two-phase alternating current2N ... two-phase alternating current with neutral3 ...
8FOREWORDPorter-Cable screwdrivers are designed to install or remove various sizes andtypes of fasteners. FUNCTIONAL DESCRIPTIONCARTON CONTENTSCarton
9Never attempt to change direction of rotation while the switchis “ON”. To do so, may damage interlock feature built intoswitch. Be sure that the swit
Kommentare zu diesen Handbüchern